Note : Both the calling and receiving units must be on the same main channel and sub-channelfor the call function to work. Unit is on, but will not be Incorrect battery Install the batteries following the operated. External Speaker Jack and Mic Jack under rubber flap 7. Key Lock This feature prevents accidental channel change to the preferred settings of the unit. Do not use this device or change its batteries in potentially explosive atmospheres as sparks in such areas could result in an explosion. Channel or Tone Code Adjust the unit's setting to not set the same as target match those settings of the transceiver. Select Hi or Low by pressing the Up or Down button.
Weak or no signal received. Same symptom as Low battery. Avoid exposing the transceiver to water or extreme tempera- tures. The higher the number, the higher the sensitivity. Operation Main Channel Scan This feature allows you to monitor all channels automatically for valid signals. Replace the batteries, or charge the rechargeable battery pack when the Battery icon blinks. Do not attempt to modify or in any way increase the output of this transceiver.
The serial number of your unit can be found on a label on the back of the cabinet. Select Hi or Low by pressing the Up or Down button. Do not attempt to modify or in any way increase the output of this transceiver. Note : External speaker and microphone are not included with this standard package. To enable or disable the Roger Beep Tone, 1. While in dual watch mode, the unit will continuously monitor both the primary and dual watch channel. When a signal is received, scan is interrupted and you will hear the channal for 5 seconds.
The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. Press for 2 seconds Calling Another Party To alert another party that you wish to communicate with, 1. Both chargers are not included, but can be purchased separately. A flashing sub-channel number will be displayed on the Summary of the content on the page No. Dual Watch Mode Indicator 10. Weak or no signal Weak batteries.
External Speaker Jack and Mic Jack under rubber flap 7. If there are no transmissions within 5 seconds, the unit will automatically switch to Battery Save Mode. To select your favorite call tones, 1. Push the Up or Down button to select your favorite call tone. Charger and rechargeable batteries not included.
Note : Whenever the unit is on, you can receive communications. If using rechargeable batteries, recharge them. Built-in Microphone Page 3 8. Received signals will be heard for 5 seconds, then the unit will resume scanning the two channels. Turn your transceiver off wherever posted notices restrict the use of radios or cellular phones.
Wait for the party's response or proceed to talking with the other party. Press the Up or Down button to select the desired sub-channel. Low Battery Indicator When the batteries are low and need re-charging,the icon will be blinking and audible beep tones will sound. If there are no transmissions within 5 seconds, the unit will automatically switch to Battery Save Mode. Simply raise the rubber flap and insert the microphone plug into the microphone jack on the top of the unit.
The icon will disappear and normal operation will resume. Both chargers are not included, but can be purchased separately. These limits are designed to provide reasonable protection against harmful interference in a residential installation. To select your favorite call tones, 1. Received signals will be heard for 5 seconds, then the unit will resume scanning the two channels.