It is an Energy Star® qualified and fully featured model. I'm sorry to say that portable dehumidifiers just don't last very long. If none of the instructions above helped solve your problem, it may be a case of the compressor needs to be recharged with refrigerant gas. If your refrigerator will not start, one of the most common parts to fail is the compressor start relay. This could also happen to a dehumidifier that has operated for less time. This is a safety device to prevent the unit from overflowing.
To remove the filter properly, pull the tabs using your hands in order not to scratch them and then take out the filter. . When the switch is tripped, power to the compressor and fan motor circuits is disrupted until the bucket is emptied. The float will trip the water level switch when the bucket is full. Inspect it and clean it if necessary. If this happens, the unit will automatically shut off. Make sure that the float assembly can move or pivot freely so that it can trigger the level switch when the bucket is full.
You may need to perform a continuity test on the switch to determine if the part has indeed failed since you cannot tell by looking at it. Unplug the humidifier from the power source as a safety precaution before beginning this repair. Never dreaming I could find a replacement, I went searching on the internet anyway and found the model which had been discontinued however the container and float were still available. Anti Microbial Filter Removes some harmful bacteria and allergens. No tools are necessary to replace this part, simply unplug the old part and push the new replacement plug into the plug hole. If your control unit is not consistently monitoring the air and unable to turn off, make sure to check for damage and replace if necessary.
This device is located near the bucket and moves up as the water level in the bucket rises. This genuine replacement drain plug, also known as a drain cap, is manufactured for a dehumidifier. Other common symptoms connected to start relays include: refrigerator will not start, will not cool, is making a clicking, humming or buzzing sound, or the compressor itself is warm to the touch. Refer to the manual provided by the manufacturer for installation instructions and further guidance. You are unlikely to find a new example for sale although there may still be a few available here and there. All you have to is to empty the water bucket and return it back to position.
No matter which brand you buy you are probably going to have to replace it after a couple of years. Frigidaire Dehumidifier Not Working If your dehumidifier is freezing up, then try these simple solutions first. The accuracy of the humidistat has been confirmed in a significant number of reviews. I am quite happy to recommend it, particularly if you can get it at a good price. Auto-Defrost Turns off the compressor to allow ice on the cold coils to melt.
The compressor start relay attaches to the compressor in your refrigerator. If the assembly is warped or damaged it should be replaced. This part is black in color, is approximately 0. This humidity control, also known as a humidistat unit, is used in dehumidifiers. Then run the filter under clean water then dry it. Simply set it to 32-35%. Shake the relay and listen for any rattling, as this is a sign that it is faulty.
This page is being maintained primarily for any of you who may wish to buy a pre-used or refurbished unit and need some information about it other than that provided by the seller. These solutions are applicable to Frigidaire 30, 50 , and 70 pint dehumidifiers models. My Recommendation So far as noise goes there are two things to say. Continuous Drainage The water condensed on the cold coils can be run off to a floor drain through a hose attached to the outlet port. The auto shut off switch is for dehumidifiers. In this case, contact the manufacturer or consult other resources on our website.
This protects the appliance in cooler temperatures. If the bucket is full indicator on your dehumidifier is on, but the bucket is empty, or your dehumidifier is overflowing, you may have a problem with the float. Remove the air filter by pulling the tabs. Users like the electronic controls and find them simple and intuitive to use. Without the plug, your dehumidifier will not be able to hold water. Manual Click on the link to download the. Adjustable Humidistat Once programmed the humidistat switches the compressor on only when humidity rises above the level set.
You may also smell a burnt plastic odor if the relay has failed. The control monitors and detects when the air is damp and will signal to turn off and on automatically so you do not have to worry about manually controlling this. Sometimes called the controller, this device is used to boost the compressor until the unit is running. Make sure your dehumidifier is unplugged before you begin. Once the filter is dry, replace it on the rear of the dehumidifier and snap in place. Some find the water bucket a mite tricky to remove. Frigidaire Dehumidifier Not Collecting Water To resolve this problem , follow these steps given by an expert.